Microsens MS655033X Instrukcja Użytkownika

Industrial IEEE 802.3at Gigabit PoE Injector User Manual v.1.0 Jun-2011

Front Panel On the front panel the Power over Ethernet Injector is equipped with two RJ-45 ports and three LED indicators.  LAN port: It is an or

Top View Designed with two power inputs, the PoE Injector allows users to supply redundant power rating in the range of 24 to 48V. PWR1PWR2V2-V2+

Grounding the PoE Injector Follow the instructions below to attach the PoE Injector to ground. When installing the PoE Injector, the ground conne

Wiring the Power Inputs Please follow the steps below to wire power lines from the terminal block to the compliant external DC power source. 1. Bef

RJ-45 Pin Assignments The UTP/STP ports will automatically sense for Fast Ethernet (10Base-T/100Base-TX) or Gigabit Ethernet (10Base-T/100Base-TX/10

 10/100Base-TX Cable Schema Straight Through Cable Schema Crossover Cable Schema  10/100/1000Base-T Pinouts The table below describes the

 10/100/1000Base-T Cable Schema The following two figures illustrate the 10/100/1000Base-T cable schema. Straight Through Cable Schema Crossover

14 Installation DIN-Rail Mounting Assembling the DIN-Rail Clip The DIN-rail clip is screwed on the device in the factory. If not, please refer to

Hanging the PoE Injector Follow the steps below to hang the device on the standard DIN rail. 1. First, position the rear side of the unit directly

Wall-Mount Plate Mounting Follow the steps below to mount the device with the wall-mount plates. 1. To remove the DIN-Rail clip from the device, un

FCC Warning This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.

Troubleshooting  Verify that you are using the right power cord/adapter. Please don’t use a power adapter with DC outputs higher than the power r

Content FCC Warning... i CE Mark Warning ... i Over

Overview Introduction The Industrial Power over Ethernet Injector provides data and DC power through the Ethernet cable to PoE-equipped devices, su

Features  10/100/1000BaseT Power over Ethernet Injector  IEEE802.3at compliant  Provides power feeding up to 30 watts  Overload current prote

Specifications Standard IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX IEEE802.3ab 1000Base-T IEEE802.3af/at Power over Ethernet Connector LAN port: Data/

Operating/Storage Humidity 5% ~ 95% Humidity (non-condensing) Dimensions 30mm x 140mm x 95mm (W x H x D) EMC CE, FCC Class A EN61000-6-4 EN6100

5 Packing List  1 x Power over Ethernet Injector  1 x Wall-mounting kit  1 x User Manual (CD-ROM)

Hardware Description Dimensions The Power over Ethernet Injector dimensions are 30 mm (W) x 140 mm (H) x 95 mm (D) 6